/network/if-info
Use the interface to obtain network card information.
Request Mode
POST /api/network/if-info
Response Body
{
"device-name": "USB Fusion yxy1",
"net": [
{
"enable": true,
"iface": "eth0",
"type": 0,
"use-dhcp": true,
"ipaddr": "10.10.12.166",
"netmask": "255.255.240.0",
"gateway": "10.10.0.1",
"mac": "84:85:86:87:88:2e",
"link-speed": 1000,
"link-state": 2,
"tx-speed-kbps": 0,
"rx-speed-kbps": 107
},
{
"enable": true,
"iface": "wlan0",
"type": 1,
"mode": 1,
"ssid": "USB-Fusion_yx_5G",
"use-dhcp": true,
"ipaddr": "192.168.67.1",
"netmask": "255.255.255.0",
"gateway": "",
"mac": "10:2c:6b:fd:9b:78",
"link-speed": -1,
"link-state": 2,
"tx-speed-kbps": 3,
"rx-speed-kbps": 0
},
{
"enable": true,
"iface": "usb0",
"type": 3,
"use-dhcp": true,
"ipaddr": "192.168.66.1",
"netmask": "255.255.255.0",
"gateway": "192.168.66.1",
"mac": "8e:40:df:be:7c:fa",
"link-speed": 480,
"link-state": 2,
"tx-speed-kbps": 0,
"rx-speed-kbps": 0
}
],
"status": 0
}
| Name | Description |
|---|---|
| status | 0 indicates that the request was accepted successfully. Refer to API Status Codes to find specific description for other values. |
| device-name | The device name |
| net[i].enable | Whether the network card service is enabled |
| net[i].iface | The network card name |
| net[i].type | The network card type 0: Ethernet 1: WiFi 2: 4G module 3: USB |
| net[i].mode | The working mode of WiFi When net[i].type == 1 exists, 0: STA mode 1: AP mode |
| net[i].ssid | The WIFI ssid |
| net[i].reboot-require | WiFi reboots and takes effect. |
| net[i].use-dhcp | True: use DHCP to get the IP False: use the static network configuration |
| net[i].ipaddr | The IP address |
| net[i].netmask | The subnet mask |
| net[i].ipv6addr | The IPv6 address |
| net[i].gateway | The gateway address |
| net[i].mac | The MAC address |
| net[i].link-speed | The link speed 10: 10Mbps, 100: 100Mbps, 1000: 1Gbps, 2500: 2.5Gbps, 10000: 10Gbps The speed supported by USB 12: full-speed, 480: high-speed, 5000: super-speed-5g, 10000: super-speed-10g |
| net[i].link-state | The link state 0: down 1: disconnected 2: connected |
| net[i].vendor | The vendor of the 4G module |
| net[i].product | The product information of the 4G module |
| net[i].tx-speed-kbps | The sending speed (Kbps) |
| net[i]. rx-speed-kbps | The receiving speed (Kbps) |